Most of the time, companies would spend lots of money to buy their lift trucks. It is important, therefore to take proper care of your machine to protect your investment into the long run. It is a great idea to know the procedures that are carried out in taking care of and maintaining this machinery.
By starting up the forklift and listening closely how it runs is one of the best ways to tell how good the engine is working. Like for instance, if there are any misses or knocks, the equipment is faulty and this must raise several issues. What's more listen carefully for any squealing sounds which come from the belts since these sounds will provide you with a lot of information.
When performing maintenance, some of the main components you would have to pay attention to comprise the safety warning devices, horn, the overhead guard, the lights and the gauges. Any burnt out light bulbs or faulty components must be replaced as soon as they are noticed. It is also vital to check the wiring.
The battery compartment terminals should be cleaned when the above parts have been inspected carefully. If the terminals are not clean, be sure to clean them well. Each and every cell of the battery needs to be checked in order to make certain that the fill level is topped up to the regulated amount.
The next step is to drain all of the oil out of the machine and after that change the filters. The hydraulic filter, the transmission filter and the fuel filters must be regularly replaced. Before fitting them, be sure to write the date on the new filters by utilizing a permanent marker in order to keep track.
When the oil change is finished and the filters have been replaced, a visual inspection of the drive axle has to be done. If there is a grease fitting on the axle make sure to apply some grease. Inspect the engine belts for any frays or cracks. If you find any, fix the problem accordingly. After that, inspect every other component of the machine including the wheels. If any type of issue or fault is detected, be certain to address it immediately in order to make certain the equipment is working at its safest and optimum levels.